Cabletron Systems SEHI100TX-22 manual Chapter Installation, Unpacking The Sehi

Models: SEHI100TX-22

1 88
Download 88 pages 20.99 Kb
Page 27
Image 27
CHAPTER 4

CHAPTER 4

INSTALLATION

This chapter outlines the procedure for attaching the SEHI to the network as a stackable or standalone device. Ensure that the network meets the guidelines and requirements outlined in Chapter 3, Installation Requirements and Specifications, before installing the SEHI.

NOTE

A single phase grounded power receptacle that meets the requirements listed in Chapter 3 must be located within seven feet of the installation.

Failure to follow installation instructions may result in an electrical shock hazard.

4.1UNPACKING THE SEHI

Unpack the SEHI as follows:

1.Remove the shipping material covering the SEHI in the shipping box.

2.Carefully remove the SEHI from the shipping box and set it aside to prevent damage.

3.Visually inspect the SEHI. If there are any signs of damage, contact Cabletron Systems Technical Support immediately. Refer to Section 1.3 for instructions on getting help.

4.Read the SEHI Release Notes included in the shipping box.

NOTE

Cabletron Systems includes a 3 1/2-inch disk with the SEHI100TX-22 that contains a backup copy of the FLASH Firmware Image File. Download the file to the SEHI100TX-22 if the existing image becomes corrupted. Refer to Appendix B for detailed download instructions.

SEHI100TX User’s Guide

4-1

Page 27
Image 27
Cabletron Systems SEHI100TX-22 manual Chapter Installation, Unpacking The Sehi