Setting the NVRAM Switch
6.4SETTING THE NVRAM SWITCH
To prevent the possibility of electrical shock, do not remove the chassis cover to access the NVRAM switch, and use only a
The SEHI uses NVRAM to store
1.With the power ON and using a
2.Press the RESET switch located on the front panel.
3.Wait until the unit boots (approximately 12 seconds).
4.Return the NVRAM switch to the DOWN position.
Failure to return the NVRAM switch to the DOWN position will
!result in loss of
CAUTION | and restart. The SEHI will clear NVRAM if the unit is restarted |
| |
| with the switch in the UP position. |
Rear of Chassis
NVRAM Switch located behind grating
1511_02
Figure
SEHI100TX User’s Guide |