Cabletron Systems manual Post-Installation, Installing the WPIM-RT1

Installing the WPIM-RT1

4.Press down firmly on the WPIM-RT1 until the pins slide all the way into the connector. Ensure that the WPIM-RT1 seats flush on the standoffs.

5.Secure the WPIM-RT1 to the three standoffs with the WPIM screws.

WPIM Screws

WPIM

Connector

WPIM

WPIM

Connector Pins

Standoffs

Figure 2-2 Installing the WPIM-RT1

2.1.4Post-Installation

1.Reinstall the cover if applicable.

2.Refer to the host platform user’s guide to reinstall the network cables and refer to Appendix A for cabling information for the WPIM-RT1. Do not connect the WAN cable at this point.

3.Refer to instructions contained in the host platform user’s guide to reapply power.

4.After reapplying power, check the LEDs for the following conditions:

•Verify that the PWR LED is on, indicating that the device is receiving power.

•After the host platform runs a self test, the CPU LED blinks green indicating normal operation.

•If the CPU LED remains red, contact Cabletron Systems.

WPIM-RT1 User’s Guide 2-3