RF400 Series Spread Spectrum Data Radio/Modems

2.Point-to-multipoint

a.Complete steps 1 to 4 above making the remote stations’ Network Addresses and Hopping Sequences the same as the base station’s.

b.While in Standard Setup verify that the active interface is “Auto Sense” and give each remote RF400 a unique Radio Address.

You should label each RF400 (with masking tape) indicating the configured network address, radio address, hopping sequence, etc.

c.Exit and Save your configuration by pressing “5”.

3.Antenna considerations

a.Line of sight – the single most important factor in radio performance is antenna placement. As Appendix H states, “height is everything.” The two RF400s must be able to ‘see’ each other if distances over a mile or two are required. This can be accomplished with a mast or tower.

b.Mounting – the higher the gain of a yagi antenna, the more important it is to aim the yagi precisely and mount the yagi solidly to prevent movement due to strong winds, large birds, etc.

c.Antenna cable routing – the antenna cable should be routed in a protected area and made secure against damage from wildlife, wind, and vandalism.

d.Antenna cable weather sealing – the presence of water inside the antenna cable’s plastic sheath can attenuate your transmitted and received signals significantly. The RF energy, instead of traveling the length of the cable with little loss, is absorbed according to the amount of water present (like in a microwave oven). A small amount of water can ruin a once good communication link.

When moisture gets inside the sheath it is very difficult to remove. Some careful cable handling (even pinholes can let in significant amounts of water), thoughtful cable routing, and good weather- proofing can prevent this.

Apply a 1/8 inch thick coat of pure silicone rubber compound (RTV)

1)where the cable connector screws onto the antenna connector (apply after the connector is in place allowing future removal) and

2)at the junction between plastic cable sheath and cable connector. If carefully done this should last for years. An alternative approach is to wrap self-vulcanizing rubber tape around these same areas of the antenna connector, cable connector and cable sheath. This tape can be purchased at most electrical supply stores (see Troubleshooting Section 6, item 6).

4.Site considerations

Location of an RF400 near commercial transmitters, such as at certain mountaintop sites, is not recommended due to possible “de-sensing” problems for the RF400 receiver. A powerful signal of almost any frequency at close range can simply overwhelm a receiver. Lower

24