SETTING THE SCANNER

For example, the illustration shows the vertical set for 4 and the horizontal set for 7. The shaded area is the area trimmed and se- lected for scanning.

3.To save the setting, press the Border Button. The setting remains in effect even after the power is turned off and turned again.

Using the area setting cursors (optional)

With the optional Framing kit installed, you can set an area for printing, using the guides on the right side and the bottom of the screen. The area framed by 4 cursors will be scanned.

Border removal

Border removal allows you either to remove all the black border around the image or to leave a narrow black margin around the image.

Removing the entire border

Press the border key on the operation panel until the () indica- tor lights and then scan the image.

Leaving a margin around the image

Press the border key on the operation panel until the() indica- tor lights and then scan the image. The margin is specified in the application software.

• Border removal may not operate correctly for im- ages with ill-defined borders.

This function cannot be used when any part of the image is outside the specified range.

If multiple images are displayed on the screen at the same time, the wrong image may be scanned.

This function can only operate if there is a clear area of at least 5 mm around the image.

3.Press the Print Number Setting key (+ or ) to set the [DATE, TIME].

37

MS 300_english.p65

37

07.5.14, 10:14

Page 39
Image 39
Cannon 300II manual Border removal, Using the area setting cursors optional, Removing the entire border