Photos

Refer to this chapter for details on shooting photos – taking photos and playing them back, capturing photos from video and printing photos.

Basic Recording

Taking Photos

1Set the mode dial to .

2Turn on the camcorder.

By default, photos are recorded on the hard disk. You can also set the memory card as the recording media for photos ( 31).

3 Press PHOTO halfway.

Once the focus is automatically

adjusted, will turn green and one or more AF frames will appear.

When you press PHOTO on the wireless controller, the photo is

recorded after the autofocus is activated and locked.

4 Press PHOTO fully.

The ACCESS indicator will flash as the photo is being recorded.

IMPORTANT

Observe the following precautions while the ACCESS indicator is on or flashing. Failing to do so may result in permanent data loss.

-Do not subject the camcorder to vibrations or strong impacts.

-Do not open the memory card slot cover.

-Do not disconnect the power source or turn off the camcorder.

-Do not change the position of the mode dial.

NOTES

If the subject is not suitable for

autofocus, turns yellow. Adjust the

focus manually ( 47).

When the subject is too bright, [Overexp.] starts flashing. In such case, use the optional FS-H37U ND filter.

59

Page 59
Image 59
Cannon HG20 instruction manual Taking Photos, Press Photo halfway, Once the focus is automatically, Press Photo fully