Setting the Time Code
2 Select [Set] and then press the joystick.
• The time code setting screen appears with an orange selection frame indicating the hours.
• To reset the time code to [00:00:00.00], select [Reset] instead. If the running mode is set to [Free Run], the time code will be reset the moment you press the joystick and keep running continuously from 00:00:00.00.
3Push the joystick up/down to set the hours and then press the joystick to move to the minutes.
4 Change the rest of the fields (minutes, seconds, frame) in the same way.
•Press the CANCEL button to close the screen without setting the time code.
5Select [Set] and then press the joystick to close the screen.
•If the running mode is set to [Free Run], the time code will start running from the selected time code the moment you press the joystick.
Selecting Drop or
When [wOther Functions] >[System Frequency] is set to [59.94 Hz], | [¤TC/UB Setup] | ||
| |||
you can select between a drop frame (DF) or | [Time Code] | ||
code, depending on how you plan to use your recordings. | |||
| |||
In the following cases, the time code is set to | [DF/NDF] | ||
cannot be changed. | |||
- | [wOther Functions] >[System Frequency] is set to [50.00 Hz] |
| |
- | [wOther Functions] >[System Frequency] is set to [59.94 Hz] and | [DF] | |
| the frame rate is set to 24P |
| |
|
| ||
1 Open the [DF/NDF] submenu.
[¤TC/UB Setup] >[Time Code] >[DF/NDF]
2 Select [DF] or [NDF] and then press the joystick.
•The time code display will differ depending on the setting. When you select [DF], the time code will appear as [00:00:00.00]; when you select [NDF], it will appear as [00:00:00:00].
Putting the Time Code Display on Hold
If you set an assignable button to [Time Code Hold] (A89), you can press the button to freeze the display of the time code. While the time code display is put on hold, [H] will appear on the screen next to the time code. The time code continues to run normally while the time code display is on hold. When you resume the time code display, the current time code will be displayed.
About the Time Code Display
An icon may appear next to the time code depending on the operation. Refer to the following table.
Icon | Description |
|
|
RThe time code is set to [Regen.].
PThe time code is set to [Preset] and the running mode is set to [Rec Run].
FThe time code is set to [Preset] and the running mode is set to [Free Run].
HTime code display is on hold.
No icon Time code during clip playback.
71