Canon Setting the User Bit

Setting the User Bit

Setting the User Bit

The user bit display can be selected from the date or the time of
	[¤TC/UB Setup]
recording, or an identification code consisting of 8 characters in the
hexadecimal system. There are sixteen possible characters: the numbers	73
0 to 9 and the letters A to F.	[User Bit]
Operating modes:	[Type]
1 Open the user bit [Type] submenu.
	[Setting]
[¤TC/UB Setup] >[User Bit] >[Type]

2 Select the desired user bit type and then press the joystick.

•Select [Setting] to set your own identification code, [Time] to use the time as user bit, or [Date] to use the date as the user bit.

•If you selected [Time] or [Date], you do not need to perform the rest of the procedure. If you selected [Setting], continue the procedure to set the identification code.

3 Select [Set] and then press the joystick.

•The user bit setting screen appears with an orange selection frame on the leftmost digit.

•To reset the user bit to [00 00 00 00], select [Reset] instead.

4 Push the joystick up/down to select the first character and then press the joystick to move to the next digit.

•Change the rest of the digits in the same way.

•Press the CANCEL button to close the screen without setting the user bit.

5 Select [Set] and then press the joystick to close the screen.

NOTES

•User bit output: The user bit will be output along with the video output from the HDMI OUT terminal. In mode, when the frame rate is set to PF24 or 24P, you can output the user bit as 2:3 pulldown data by setting [¤TC/UB Setup] >[User Bit] >[Output Mode] to [Pulldown].