Feeding Options

This section describes the procedure for selecting the method for feeding documents.

1Click the [Others] tab → select the document feeding method in [Feeding Option].

NOTE

• Details of each feeding method are indicated below.

[Standard Feeding]

This feeding method is good for scanning small batches of documents that are loaded one batch at a time: scanning stops when the loaded documents have been scanned.

[Panel Feeding]

This feeding method is good for scanning batches of documents of different sizes: after loading the documents, press the Job button (assigned as a Start button on the scanner) to start scanning, and press the assigned Stop button to stop scanning.

yWhen scanning documents with different-size pages, after loading the documents, you can adjust the document guide position.

[Automatic Feeding]

This feeding method is good for scanning batches of same-size documents: scanning starts when the scanner detects loaded documents, and stops when you press the Stop button.

Contents

Back

 

Previous Page Next Page

yWhen [Automatic Feeding] is selected, the [Setting] button is enabled to allow setting the delay time from when a loaded document is detected until scanning starts. The delay time can be set from 0 to 60 seconds.

Batch Separation (ISIS driver only)

When the separation timing to use when scanning starts with batch separation enabled in the application. (If [Standard Feeding] is selected, batch separation is disabled.)

If you selected [Panel Feeding] or [Automatic Feeding] for the feeding method:

[Auto]

Document batches are separated automatically.

[Panel]

Document batches are separated when the [Batch Separation] button on the Scan Panel is pressed. (See "Using the Scan Panel," on p. 28.)

52

DR-2010C //DR-2510C