Troubleshooting Guide
If there is a problem, first refer to this Troubleshooting Guide.
Power Source
The battery cannot be recharged.
¡You are using the wrong battery.
sDo not recharge any battery pack other than Battery Pack BP- 511A,
¡The battery is not properly attached to the battery charger. s Attach the battery properly to the charger. (p.18)
The camera does not operate even when the <4> switch is set to <1> or <J>.
¡The battery is exhausted. s Recharge the battery. (p.18)
¡The battery is not installed properly. s Install the battery properly. (p.20)
¡Battery compartment cover is not closed.
sClose the battery compartment cover tightly. (p.20)
¡ CF card slot cover is not closed.
sClose the CF card slot cover firmly. (p.24)
The access lamp blinks even when the <4> switch is set to <2>.
¡If you set the <4> switch to <2> right after shooting, the
access lamp will still light/blink for a few seconds while the image is recorded onto the CF card.
sWhen the camera finishes recording the image to the CF card, the access lamp will stop blinking and the power will turn off automatically.
The battery becomes exhausted quickly.
¡The battery is not fully charged. s Recharge the battery fully. (p.18)
¡The battery’s service life has expired. s Replace the battery with a new one.
150