Mirror LockupN

Mirror lockup is enabled with C.Fn-12 [Mirror lockup] set to [1: Enable] (p.144). The mirror can be swung up separately from when the exposure is made. This prevents mirror vibrations which may blur the image during close-ups or when a super telephoto lens is used. Set Custom Functions with [cCustom Functions (C.Fn)].

1

2

Press the shutter button completely.

sThe mirror will swing up.

Again press the shutter button completely.

sThe picture is taken and the mirror goes back down.

¡In very bright light such as at the beach or ski ground on a sunny day, take the picture promptly after mirror lockup.

¡During mirror lockup, do not point the camera lens at the sun. The sun’s heat can scorch and damage the shutter curtains.

¡If you use bulb exposures, the self-timer, and mirror lockup in combination, keep pressing the shutter button completely (2 sec. self- timer + bulb exposure time). During the self-timer countdown, if you let go of the shutter button, there will be a shutter-release sound. This is not the shutter release (no picture is taken).

¡During mirror lockup, the drive mode will be single shooting regardless of the current drive mode (single or continuous).

¡If you use the self-timer and mirror lockup, the shot will be taken 2 sec. after the mirror goes up when you press the shutter button completely.

¡The mirror locks up, and after 30 seconds, it will go back down automatically. Pressing the shutter button completely again locks up the mirror again.

¡For bulb exposures, using Remote Switch RS-80N3 or Timer Remote Controller TC-80N3 (both optional) is recommended.

88