Canon H323 manual QOS Option Settings, Secondary Ethernet Hub/IR Interface Enable/Disable

Static Administration Options:

4.1 QOS Option Settings

Administering QoS options is not mandatory, but it is highly recommended. Use the following procedure to set Quality of Service (QoS) options.

1.While the phone is on-hook and idle, press the following sequence: MUTE 7 6 7 # (MUTE Q O S #).

2.The current 802.1Q settings are shown in sequence:

∙L2 audio=

This is the phone's current 802.1 audio parameter. To accept the current value, press # or enter a value (between 0 and 7) and then press #.

∙L2 signaling=

This is the phones 802.1 signaling parameter. To accept the current value, press # or enter a value (between 0 and 7) and then press #.

∙L3 audio=

This is the phone's Differential Services audio parameter. To accept the current value, press # or enter a value (between 0 and 63) and then press #.

∙L3 signaling=

This is the phone's Differential Services signaling parameter. To accept the current value, press # or enter a value (between 0 and 63) and then press #.

3.If no new values were entered during this procedure, No new values is displayed. To end the procedure, press #.

4.If new values were entered during this procedure, Save new values? is displayed. To end the procedure or save the new values, press #. New values being saved is displayed and the phone returns to normal operation.

4.2Secondary Ethernet (Hub)/IR Interface Enable/Disable

Use the following procedure to enable or disable the hub interface found on some H323 IP phones (usually marked with a symbol). The default for the hub interface is enabled.

The same procedure can also be used to enable or disable the IR port found on some H323 IP phones, see Infrared Dialling 66 .

1.While the phone is on-hook and idle, press the following sequence: MUTE 4 6 8 # (MUTE I N T #). The phones port settings are shown in sequence. The option vary between different models of phone.

∙PHY2=

This is the PC connection LAN socket marked as on the phone. Press 1 or 0 to enable or disable the hub interface respectively. To continue, press #.

∙IR=

This is the infrared (IR) port located on the front of some H323 IP phones. Press 1 or 0 to enable or disable the hub interface respectively. To continue, press #.

2.If you changed the setting, If you press #, New values

Save new values? is displayed. To end the procedure or save the new values, press #. being saved is displayed and then returns to normal operation.

H323 IP Telephone Installation	Page 55
IP Office Release 6	15-601046 Issue 16a (15 March 2010)