Canon LV-7255 manual Part Names of the Projector, Front/Top, Rear

1. Introduction

￿Part Names of the Projector

Front/Top

Zoom Lever (See page 24)

Controls (See page 6)

KCAB

Focus Ring (See page 24)

Remote sensor (See page 10)

Lens

Adjustable Tilt Foot Lock Button (See page 23)

Adjustable Tilt Foot (See page 23)

UNEM

LOV+

LOV-
		PC TO
T	INPU	UA

R

E

WOP

NGI

RNAW

PMLA

Ventilation (inlet) / Filter Cover (See page 48)

Do not block this vent. Troubles or fire can result.

Ventilation (inlet)

Lens Cap

Be sure to remove the lens cap during projection. The cap can

deform or fire can occur.

*This security slot supports the MicroSaver ® Security System. MicroSaver ® is a registered trademark of Kensington Microware Inc. The logo is trademarked and owned by Kensington Microware Inc.

Rear

Monaural Speaker (1W)

Terminal Panel (See page 7)

						WARNING
							PO
		LAMP					WER
							AUTO PC		INPUT
									-VOL
											+VOL
VIDEO
IN	L	IO IN									BACK
		AUD
S-			R
VIDEO	MONO
IN
	L	AUD
		IO IN	R			ANA
				AUDIO		LOG	IN-1
	MONO				OUT
							AUDIO IN
							SERVICE		ANA	LOG
											IN-2
								PORT

MENU

Remote sensor (See page 10)

Ventilation (outlet)

Heated air is exhausted from here.

Do not block this vent. Troubles or fire can result.

Built-in Security Slot ( )*

AC Input

Connect the supplied power cord’s two-pin plug here, and plug the other end into an active wall outlet. (See page 19)

Main Power Switch

When you plug the supplied power cord into an active wall outlet and turn on the Main Power, the POWER indicator turns orange and the projector is in standby mode.

(See page 20)

4