3. Projecting an Image (Basic Operation)
Adjusting the Picture Size and Position
Place your projector on a flat level surface and ensure that the projector is square to the screen.
Lift the front edge of the projector to center the image vertically.
*If the projected image does not appear square to the screen then use the Keystone feature for proper adjustment. See page 25 to 26.
Move the projector left to center the image horizontally on the screen.
Adjust the Tilt Foot
1. Lift the front edge of the projector.
CAUTION:
Do not try to touch the ventilation outlet during Tilt Foot adjustment as it can become heated while the projector is turned on and during its cool down period after it is turned off.
2.Push and hold the adjustable tilt foot lock button on the front of the projector to extend the adjustable tilt foot.
NOTE: To
3.Lower the front of the projector to the desired height.
4.Release the adjustable tilt foot lock button to lock the adjustable tilt foot.
There is approximately 10 degrees (up) of adjustment for the front of the projector.
Adjusting the height of a projected image or changing projection angle will run the Auto Keystone correction function to quickly correct the vertical distortion. The "Keystone" screen will be displayed.
For operating the "Keystone" screen, see " Correcting Keystone Distortion" on page 25.
5. The rear foot height can be adjusted up to 10 mm/0.4 inch.
Rotate the rear foot to the desired height in order to square the image on the projection surface, but the vertical distance from the bottom to the desk or floor should be 10 mm/0.4 inch to make the projector horizontal on the flat surface.
NOTE: If you rotate the rear foot too much, it will come off from the bottom.
1
2 |
|
Adjustable Tilt | Adjustable Tilt Foot |
Foot Lever |
|
| 3 |
4 |
CAUTION:
Do not use the
Rear Foot
23
Up Down
