zThe High-Power Flash will not fire under the following circumstances.

-When shooting in mode

-When [Flash Sync] is on [2nd-curtain]

-When [Flash Adjust] is on [Manual]

zThe flash charge time will lengthen as the battery charge gets weaker. Always set the power/mode switch to off when you finish using the flash.

zBe careful not to touch the flash window or sensor windows with your fingers while the flash is in use.

zThe flash may fire if another flash is being used in close proximity.

zThe High-Power Flash may not fire outdoors in daylight or when there are no reflective items.

zFor continuous shooting, although the flash fires for the first shot, it does not fire for subsequent shots.

zFasten the attachment screws securely so that they do not loosen. Failure to do so may lead to the dropping of the camera and flash resulting in damage to both.

zBefore attaching the bracket to the flash, check that the lithium battery (CR123A or DL123) is installed.

zTo illuminate the subjects properly, install the flash so that it is up against the side of the camera and parallel with the camera’s front panel.

zA tripod can be used even when the flash is attached.

176