Using an Eye-Fi Card

• Power saving (p. 40) on the camera is temporarily disabled during image transfer.

• Choosing mode will interrupt the Eye-Fi connection. Although the Eye-Fi connection will be restored after you choose another shooting mode or enter Playback mode, the camera may transfer any movies made in mode again.

Checking Connection Information

Check the access point SSID used by the Eye-Fi card or the connection status, as needed.

Press the nbutton, choose [Eye-Fi Settings] on the 3tab, and then press the m button.

Choose [Connection info], and then press the

m button.

The connection information screen is displayed.

Disabling Eye-Fi Transfer

Configure the setting as follows to disable Eye-Fi transfer by the card, if necessary.

Choose [Disable] in [Eye-Fi trans.].

Press the nbutton, choose [Eye-Fi Settings] on the 3tab, and then press the m button.

Choose [Eye-Fi trans.], and then choose [Disable].

•[Eye-Fi Settings] is not shown unless an Eye-Fi card is in the camera

with its write-protect tab in the unlocked position. For this reason, you cannot change settings for an inserted Eye-Fi card if the write-protect tab is in the locked position.

221