MAINTENANCE

Replacing the Lamp

When the time of use of the lamp exceeds the certain amount of time, the following message (two types) is displayed for 10 seconds every time the projector is turned on.

zIf the time of use is:

SX7 MarkII/X700 : 1800 to 2000 hours

SX60

: 2400 to 2500 hours

* [<], [>], the [OK] button, and the [POWER] button are available during this message is displayed.

zIf the time of use is:

SX7 MarkII/X700 : 2000 hours or more

SX60

: 2500 hours or more
* The [POWER] button is available during this message is displayed.

z This message will not be displayed again if you select [Cancel] in response to the message "Do you want to display this message again?".

zYou can check the time of use of the lamp in [Lamp counter] in the [System settings] menu (P118).

zWhen replacing the lamp, turn off the projector, wait until the cooling fan stops,

remove the power plug from the AC outlet, and let the projector stand for at least 1

Caution hour. Otherwise, you may get burned because the main unit is very hot immediately after the projector is turned off.

zDo not touch the inner glass surface when you replace the lamp. Otherwise, the pro- jector's performance may degrade.

zMake sure to handle the lamp carefully and correctly since it may explode if it is scratched or shocked.

zDo not remove screws unless specified.

Replacing LampThis projector uses the following lamp.Lamp type No. SX7 MarkII/X700 : RS-LP04

SX60

: RS-LP03

z Be sure to use the specified lamp.

z A lamp can be ordered from your dealer or Canon home page.

122