Precautions on Handling the Batteries in the Remote Controller

Observe the following precautions when handling the batteries. Failure to do so may cause explosion, heat generation, fire, or leakage of the battery fluid.

Caution z Do not heat or disassemble the batteries, or throw them into fire.

zDo not attempt to recharge the batteries.

Observe the following precautions when handling the batteries. Failure to do so may cause explosion, heat generation, fire or leakage of the battery fluid.

Warning z Remove the batteries when they have been exhausted or not in use for an extended period of time.

zBe sure to replace both batteries at the same time. Do not mix batteries of different types.

zInsert batteries correctly according to the "+" and "–" markings.

zIf a fluid from a battery leaks and comes in contact with your skin, rinse the affected skin thoroughly as soon as possible.

Lamp Handling Precautions

This projector uses a high-pressure mercury lamp which must be handled carefully and correctly as mentioned below.

The mercury lamp has the following characteristics.

zA lamp may explode with a loud sound or burn out due to a shock, scratch, or use beyond its expiry date.

zThe lamp life may differ from lamp to lamp and according to the usage environment. There is no guarantee that all lamps will last for the same period of time. Some lamps may fail in a shorter period of time than other similar lamps.

zA lamp gradually becomes darker over time.

If a Lamp Explodes

z If a lamp explodes, gas or dust may come out of the exhaust vent. Open

Warning windows and doors for ventilation.

zThe gas contains toxic mercury. Always keep your face away from the exhaust vent when the projector is operating to avoid inhaling mercury vapors or to prevent it from getting in your eyes or mouth.

zIf you inhale the gas or the shards of the broken lamp contact your eyes or mouth, consult a doctor immediately.

zIf a lamp explodes, its shards may scatter inside the projector. Ask the Canon service representative to clean and check the inside of the projector and replace the lamp.

If the projector indicates that the lamp should be replaced (i.e., the LAMP REPLACE indicator lights up twice),

Caution z The chances of an explosion increase. Replace the lamp with a new one immediately if such is the case.

INSTRUCTIONS SAFETY

13