Special Recording Modes

4Press the START/STOP button again to stop recording.

•All of the recorded frames are joined together into one clip.

•The tally lamps go out and [INT STBY] appears at the top of the screen (with [INT] flashing).

NOTES

89

•You can use only one special recording mode at a time.

•While recording, you cannot change the interval or number of frames.

•Some frames at the point the recording was stopped may be recorded and added to the end of the clip.

•Interval recording mode will be deactivated if the special recording mode is changed or turned off. It will be deactivated also if you change the [JOther Functions] [Bit Rate/Resolution] or [Frame Rate] setting.

•The time code advances by the number of frames recorded. If the running mode of the time code (070) is set to [Free Run] or the time code is input from an external source (bonly), the running mode will switch to [Rec Run] during special recording mode. When special recording mode is deactivated, the running mode will return to its previous setting.

•bDuring special recording mode, the time code signal will not be output from the GENLOCK/TC terminal or HD/SD SDI terminal.

Frame Recording Mode

Set the number of frames in advance. We recommend using the wireless controller or stabilizing the camcorder, for example, on a tripod. Sound is not recorded in this mode.

Configuring Frame Recording Mode

1Open the [Rec Frames] submenu.

[JOther Functions] [Frame Rec] [Rec Frames]

2Select the desired number of frames and then press SET.

•Available options are 1, 3, 6 and 9 (2, 6 and 12 if [JOther Functions]

[Frame Rate] is set to [24P] or [60P]).

Activating Frame Recording Mode and Recording

1Open the [Special Rec] submenu.

[JOther Functions] [Special Rec]

2Select [Frame Rec] and then press SET.

•[FRM STBY] appears at the top of the screen (with [FRM] flashing). 3 Press the START/STOP button to begin recording.

•The camcorder automatically records the set number of frames.

•The tally lamps illuminate.

[JOther Functions]

[Frame Rec]

[Rec Frames]

[1]

[JOther Functions]

[Special Rec]

[Off]

•[FRM STBY] changes to [NFRM REC] while recording frames and [NFRM STBY] when frames are not being recorded.

•Repeat until you finish recording.

4Open the [Special Rec] submenu.

[JOther Functions] [Special Rec]

5Select [Off] and then press SET.

•Frame recording mode ends and all of the recorded frames are joined together into one clip.

•The tally lamps go out and [STBY] appears at the top of the screen.