RACEWAY
HOLE IN END PANEL (HIDDEN)
C08027
Fig. 22 - Field Control Wiring Raceway
Electric Heaters
50HCQ units may be equipped with
Heater modules are installed in the compartment below the indoor (supply) fan outlet. Access is through the indoor access panel. Heater modules slide into the compartment on tracks along the bottom of the heater opening. See Fig. 23, Fig. 24 and Fig. 25.
DISCONNECT MOUNTING
LOCATION
UNIT | OUTDOOR | INDOOR |
ACCESS | ||
PANEL | ACCESS PANEL | PANEL |
|
| C08133 |
Fig. 23 - Typical Access Panel Location
Not all available heater modules may be used in every unit. Use only those heater modules that are UL listed for use in a specific size unit. Refer to the label on the unit cabinet for the list of approved heaters.
Unit heaters are marked with Heater Model Numbers. But heaters are ordered as and shipped in cartons marked with a corresponding heater Sales Package part number. See Table 2 for correlation between heater Model Number and Sales Package part number.
NOTE: The value in position 9 of the part number differs between the sales package part number (value is 1 or 3) and a bare heater model number (value is 0).
50HCQA
Table 2 – Heater Model Number
Bare Heater Model Number | C | R | H | E | A | T | E | R | 0 | 0 | 1 | A | 0 | 0 |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Heater Sales Package PNO |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Includes: |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Bare Heater | C | R | H | E | A | T | E | R | 1 | 0 | 1 | A | 0 | 0 |
Carton and packing materials |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Installation sheet |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
DISCONNECT | EMT OR RIGID CONDUIT | SINGLE | CENTER | MANUAL RESET |
MOUNTING | POINT BOX | POST | LIMIT SWITCH | |
LOCATION |
|
|
| HEATER |
|
|
|
| |
|
|
|
| COVERS |
|
| SINGLE POINT |
|
|
|
MAIN | BRACKET AND | BOX | HEATER | HEATER | HEATER |
CONTROL CONDUIT | MOUNTING | MODULE | MODULE | MOUNTING | |
BOX | DRIP BOOT | SCREW | (LOCATION 1) (LOCATION 2) BRACKET |
CONTROL WIRE TERMINAL BLOCK
C08134
Fig. 24 - Typical Component Location
15