Carrier 50TC Economizer Parts, Shipping Location, Two Position Damper Hood Removal and Setup

Remove Hood Parts

Cut Plastic Ties

(2) Places

Economizer

50TC		C08633
	Fig. 10 - Economizer Parts, Shipping Location
	Two Position Damper Hood Removal and Setup -
	Factory Option

1.	The hood is shipped in knock-down form and
	assembled to a metal support tray using plastic
	stretch wrap. Located in the return air compartment,
	the assembly’s metal tray is attached to the basepan
	and also attached to the damper using two plastic
	tie-wraps.
2.	To gain access to the hood, remove the filter access
	panel. (See Fig. 9.)
3.	Locate the (2) screws holding the metal tray to the
	basepan and remove. Locate and cut the (2) plastic
	tie-wraps securing the assembly to the damper. (See
	Fig. 11.) Be careful to not damage any wiring or cut

Economizer Hood and Two-Position Hood—

1.The indoor coil access panel will be used as the top of the hood. Remove the screws along the sides and bot- tom of the indoor coil access panel. See Fig. 12.

TOP

PANEL

	TOP
	PANEL
	CAULK
INDOOR	HERE
	INDOOR
COIL	COIL
ACCESS	ACCESS
PANEL	PANEL
	C06025

Fig. 12 - Indoor Coil Access Panel Relocation

2.Swing out indoor coil access panel and insert the hood sides under the panel (hood top). Use the screws provided to attach the hood sides to the hood top. Use screws provided to attach the hood sides to the unit. See Fig. 13.

tie-wraps securing any wiring.

4. Carefully lift the hood assembly (with metal tray)

through the filter access opening and assemble per

the steps outlined in the following procedure

Economizer Hood and Two–Position Hood.

Hood Parts

LEFT
HOOD
SIDE	19 1/16”B
	(483mm)

TOP

PANEL

INDOOR COIL

ACCESS PANEL

SCREW

33 3/8”

(848mm)

HOOD DIVIDER

C06026

Plastic Tie Wrap

Qty (2)

Screws for Metal Tray

Qty (2)

C08639

Fig. 11 - Two-Position Damper, Shipping Location

Fig. 13 - Economizer Hood Construction

3.Remove the shipping tape holding the economizer ba- rometric relief damper in place.

4.Insert the hood divider between the hood sides. See Fig. 13 and 14. Secure hood divider with 2 screws on each hood side. The hood divider is also used as the bottom filter rack for the aluminum filter.

12