Using an SD Memory Card

Saving Song Data Recorded on the Digital Piano to an SD Memory Card

You can save song data that you recorded to the digital piano’s recorder area to an SD memory card as an SMF Format 0 file or a CASIO CSR file.

PREPARATION

•Insert an SD memory card that has been formatted on the digital piano into the digital piano’s SD memory card slot. Make sure that the write-protect switch of the SD memory card is not in the write-protect position.

IMPORTANT!

•Never turn off the digital piano or perform any other operation while data is being saved to an SD memory card. Doing so can cause SD memory card data to be deleted and make impossible to store data to the card.

1. Press the RECORDER button so the PLAY lamp is lit.

2. Use the /NO and /YES buttons to select the song data (song number 1 through 5) you want to save.

3. Hold down the CARD button until its lamp starts to flash slowly and “Ldr” (Load recorder area) appears on the display.

4. Press the CARD button again.

•This will cause the CARD button lamp to flash at a higher speed and “SvC” (Save as CSR file) to appear on the display. This setting will save song data in CASIO CSR format.

•If you want to save the song data in SMF Format 0, press the CARD button again. This will cause “SvS” (Save as SMF0 file) to appear on the display.

5. Use the /NO and /YES buttons to select the file number where you want to save the song data.

This mark indicates that the currently displayed file number on the SD memory card has data stored already.

6. When everything is the way you want, press the TEMPO/SETTING button to begin saving data.

•The message “CPL” (ComPLete) will appear on the display to let you know when the save operation is complete. After that, the digital piano will return to playback standby.

zTo cancel the save operation, press the CARD button.

zIf the SD memory card already contains a data file with the same file number, pressing the TEMPO/ SETTING button in step 6 will display “rEP” (rEPlace) to confirm that you want to replace the existing file with the file you are saving. Press the /YES button to overwrite the existing data file or the /NO button to cancel.

E-37