General Guide

I

Using the TEMPO/SETTING Button

Normally when you press a button, it will change the setting or perform the operation marked above the button. Note that there also are secondary parameters (settings) marked below some buttons that you can select using the TEMPO/SETTING button.

•For details about the parameters you can configure using the TEMPO/SETTING button, see “Secondary Parameter Reference” on page E-27.

To select a secondary button parameter

1. Press the TEMPO/SETTING button.

•This will cause the lamp below the TEMPO/ SETTING button to flash.

•The GRAND PIANO 1/TEMPO button’s lamp also will flash.

Example:

2. Press the button that corresponds to the parameter you want to select.

• This will cause the button’s lamp to flash.

Example: TRANSPOSE button

•If you want to adjust the tempo, you can skip this step because the GRAND PIANO 1/TEMPO button’s lamp will flash already.

3.Use the /NO and /YES buttons to change the setting of the selected parameter.

4.After you are finished, press the TEMPO/ SETTING button again.

•This will cause the TEMPO/SETTING lamp and the lamp of the selected parameter button to go out.

/NO Button and /YES Button

Use the /NO and /YES buttons to change a displayed setting.

zHolding down either button changes the value at high speed.

Example: See “Selecting a Various tone, GM tone, and Drum set” on page E-9.

NOTE

•Pressing the /NO and /YES buttons at the same time will return the displayed setting to its default.

E-4