Casio CTK-571 manual Finishing with an Ending Pattern, Adjusting the Accompaniment Volume

Select the rhythm you want to use.

MODE SYNCHRO/ENDING

ONE TOUCH PRESET

ACCOMP VOLUME

[+]/[–]

Number buttons

To use synchro start

1. Press the SYNCHRO/ENDING button to put the key- board into synchro start standby.

Flash

2. Play a chord and the rhythm pattern starts to play au- tomatically.

❚ NOTES ❚

•If the MODE switch is set to NORMAL, only the rhythm plays (without a chord) when you play on the accompaniment keyboard.

•If you press the INTRO button before playing anything on the keyboard, the rhythm starts automatically with an intro pattern when you play some- thing on the accompaniment keyboard.

•Pressing the VARIATION/FILL-IN button before playing anything on the keyboard causes play to start with the variation pattern when something is played on the keyboard.

•To cancel synchro start standby, press the SYNCHRO/ENDING button one more time.

Finishing with an Ending Pattern

You can end your performances with an ending pattern that brings the rhythm pattern you are using to a natural-sounding conclusion. The following procedure describes how to insert an ending pattern. Note that the actual ending pattern played depends on the rhythm pattern you are using.

To finish with an ending pattern

While the rhythm is playing, press the SYNCHRO/END- ING button.

•This causes the ending pattern to play which brings rhythm ac- companiment to an end.

•The timing when the ending pattern starts depends on when you press the SYNCHRO/ENDING button. If you press the button be- fore the second beat of the current measure, the ending pattern starts playing immediately. Pressing the button at any point in the measure after the second beat results in the ending pattern playing from the beginning of the following measure.

Adjusting the Accompaniment Volume

You can adjust the volume of the accompaniment parts as a value in the range of 000 (minimum) to 127.

1. Press the ACCOMP VOLUME button.

Current accompaniment volume setting

2. Use the number buttons or the [+]/[–] buttons to change the current volume setting value.

Example: 110

❚ NOTES ❚

•The current accompaniment volume value that appears in Step 1 auto- matically clears from the display if you do not input anything within about five seconds.

•Pressing [+] and [–] buttons at the same time automatically sets an ac- companiment volume of 075.

Using One-touch Preset

One-touch preset automatically makes the settings listed below in accordance with the rhythm pattern you are using.

•Keyboard tone

•Layer, Split, or Layer Split on/off

•Layered tone (when layer is turned on), split tone (when split is turned on), or layered split tone (when layer and split are turned on)

•Tempo

•Accompaniment volume

To use one-touch preset

1.

2. Use the MODE button to select the accompaniment mode you want to use.

3. Press the ONE TOUCH PRESET button.

•This automatically makes the one-touch preset settings in ac- cordance with the rhythm you selected.

4.Play a chord and the rhythm pattern starts to play au- tomatically.

•Accompaniment is played using the one touch preset set- tings.

E-20 702A-E-022A