Problem

 

Possible Causes and Action

 

Display language setting

1)

You did not configure initial settings after purchasing the camera or the battery may have been left with

 

screen appears when the

 

a dead battery. Check the camera setup (pages 11, 215).

 

camera is turned on.

2)

The may be a problem with the camera’s built-in memory management area. If this is the case, perform

 

 

 

the reset operation to initialize the camera’s setup (page 159). After that, configure each setting. If the

 

 

 

language selection screen does not re-appear when you turn the camera on, it means that the camera’s

 

 

 

built-in memory management area has been restored.

 

 

 

If the same message appears after you turn power back on, contact your retailer or a CASIO service

 

 

 

center.

 

 

 

 

If you have problems installing the USB driver...

You may not be able to install the USB driver properly if you use the USB cable to connect the camera to a computer running Windows 98SE/98 before installing the USB driver from the bundled CD-ROM, or if you have another type of driver installed.

This will make it impossible for the computer to recognize the camera when it is connected. If this happens, you will need to re-install the camera’s USB driver.

For information about how to re-install the USB driver, see the USB driver’s “Read me” file on the CD-ROM that comes bundled with the camera.

279

APPENDIX