Casio KL-7400 21E, ■UNCUT, Select, ■FULL CUT, ■FULL+HALF CUT, When using the, 2.Print the tape, Using the printer's, 3.Press FEED to feed the tape

■FULL+HALF CUT

•FULL+HALF CUT perform a full cut at the end of each label, and a half cut near the beginning of each label to make the backing paper easier to remove.

		F
el	o
	Sr
aS roF	ela

■FULL CUT•FULL CUT performs a full cut at the end of each label.•Use this setting when printing on iron transfer tape.

•When using the NARROW and MEDIUM margin settings, this setting automatically performs a full cut to trim off excess tape.

■UNCUT

•When UNCUT is selected, the printer does not perform any cut operation between labels.

•This setting is best when you want to print labels without spaces between them, which saves label tape.

•Be sure to select UNCUT when printing on magnetic tape and reflective tape. After printing is complete, press FEED to feed the tape, and then cut it with a pair of scissors.

	F			F
elaS roF elaS	ro	el	Sr
			aS roF ela

e

laS

r

oF

elaS

F ro

Using Magnetic Tape and Reflective Tape

Special handling is required when printing on magnetic tape and reflective tape. Whenever printing on magnetic tape or reflective tape, select UNCUT as the tape cut mode, and cut the tape using a pair of scissors as described below.

Important!

•Using the printer's built-in cutter to half cut or full cut magnetic tape or reflective tape will shorten the service life of the cutter blade, and can damage the cutter mechanism.

1.Select NONE for the MARGINS setting (page 29), or UNCUT for the tape cut mode.

2.Print the tape.3.Press FEED to feed the tape.4.Use a pair of scissors to cut the tape.

21E