Casio KL-7400 Part 7 - Configuring the Printer Setup, Demo Printing, Use, SET, and, and, and, and, and, SET, Use, and, Use, and, and, SET, Press, Press, INPUT, • Use

Part 7 - Configuring the Printer Setup

The printer has a SET UP screen that you can use to configure a variety of basic settings.

■To configure the printer setup

1.Press to turn on the printer.

2.Press SET UP.

3.Use and to select the SET UP item whose setting you want to change, and then press SET.

4.Use the cursor keys to configure the settings and then press SET.When this setting

Demo Printing

Demo printing uses built-in data to demonstrate the type of tape label printing that can be performed by the printer.

Important!

•If there is label data from your last label layout session is still in memory, performing a demo print will delete it. If you think you will need the data later, save it in memory (page 45) before performing a demo print.

■To perform demo printing

1.	Make sure a tape cartridge is loaded in the printer.
	• See page 13 for information about loading tape cartridges.
2.	If the printer is on, press		to turn it off.
3.	Press	to turn on the printer.

is selected:

Change its setting like this:

4. Press SET UP.

DEFAULT FONT • Use and to select the font (page 42).

INPUT	• Use	and	to select INSERT or
	OVERWRITE (page 39).
CONTRAST	• Use	and	to adjust the display contrast.
DENSITY*	• Use	and	to adjust the print density setting.
LANGUAGE	• Use	and	to select the display language
	you want to use.
cm/inch	• Use	and	to select centimeters (cm) or
	inches as the unit of measurement.

DEMO PRINT • Use and to select PRINT, and then press SET to start demo printing.

*Certain environments and conditions may result in the printing density remaining the same, even after you change the DENSITY setting.

5.	Use	and	to select DEMO PRINT, and then press SET.
6.	Use	and	to select PRINT, and then press SET.
7.	Confirm that 1 is specified for the number of copies and CONT HALF CUT
	is specified for the tape cut mode.
	• You can change the number of copies and the tape cut mode (page 20)
	settings if you want.
	• If you are using a non-standard type of tape, select the appropriate tape
	cut mode (page 20) for the tape you are using.
8.	Press SET to start printing.
	• The demo print contents depend on the width of the tape cartridge
	currently loaded in the printer.
9.	After printing is complete, use			and	to select EXIT, and then press
	SET.
10. In response to the confirmation message that appears, press SET.

E46