Casio Not available Lamp Status, Description, Back Lamp Operation, 5.Connect the USB cable to the camera

5.Connect the USB cable to the camera.

The back lamp should		USB-AC adaptor
light red, indicating that
charging has started.
The back lamp will go out
when charging is		[USB] port
complete.
•	It takes about
	130 minutes to bring a	Small connector
	fully dead battery to a
		USB cable
	full charge.
•		(included with camera)
	A battery that has not
	been used for a long	Making sure that the 8 mark on the USB cable
	time or ambient
		connector is towards the side opposite that of the
	temperature extremes
		monitor screen, connect the cable to the camera.
	can cause charging to
	take longer than
	normal. If charging takes longer than about six hours, a timer will terminate it
	automatically, even if the battery is not fully charged. This is indicated by the
	back lamp flashing red. If the battery has not been used for a very long time,
	charging may be terminated automatically and the back lamp may start
	flashing red after only about 45 minutes. In either case, disconnect the USB
	cable from the camera and then reconnect it to resume charging.

Back Lamp Operation

Lamp Status	Description	Back lamp
Lit Red	Charging
	Abnormal ambient temperature, USB-AC
Flashing Red	adaptor problem, or battery problem
	(page 109), or charging terminated by the
	timer
Off	Charging complete

6.After charging is complete, disconnect the USB cable from the camera and then unplug the power cord from the power outlet.

19 Quick Start Basics