Casio WK3000, WK3100, WK3500 Selecting a DSP Type, Changing the Settings of DSP, Parameters, PREPARATION, Use the [+] and, Use the [+] and, Applying Effects to Tones

Applying Effects to Tones

EFFECT

Selecting a DSP Type

In addition to the 100 built-in effect types, you can also edit effect types to create your own and store them in user memory. You can have up to 100 effect types in user memory at one time. You can also select the DSP type of the last DSP enabled tone that you used. This means you always have access to the DSP type of Advanced Tones and tones you download over the Internet. To select the DSP type of the last DSP enabled tone that you used, select “ton” in step 3 of the procedure below.

Perform the following steps to select a DSP type.

PREPARATION

•When using a DSP effect, you should use the Mixer to confirm that the DSP lines of the required parts are turned on. See “Mixer Function” on page E-47 for more information.

1Press the EFFECT button so the pointer appears next to EFFECT on the display.2Press the [￿] CURSOR button.

•The DSP type setting screen will appear automatically about fives seconds after you press the button.

3Use the [+] and [–] buttons or number buttons to select the type of DSP you want.

•See the “Effect List” on page A-17 for information about the DSP types that can be selected.

•Here you could also change the parameters of the effect you selected, if you want. See “Changing the Settings of DSP Parameters” for more information.

NOTE

•The DSP type display area shows the DSP number (000 to 199), or “ton” (user tone created using DSP).

CURSOR

Number buttons

[+]/[–]

EXIT

Changing the Settings of DSP

Parameters

You can control the relative strength of a DSP and how it is applied. See the following section titled “DSP Parameters” for more information.

1After selecting the DSP type you want, use the [￿] and [￿] CURSOR buttons to display the parameter

whose setting you want to change.

• This displays the parameter setting screen.

2Use the [+] and [–] buttons or the number buttons to make the parameter setting you want.

•Pressing the [+] and [–] buttons at the same time returns the parameter to its recommended setting.

3Press the EFFECT or EXIT button.

• This exits the tone or rhythm setting screen.

E-32		735A-E-034A
WK3000_e_26-37.p65	32	04.3.26, 0:10 PM