Mixer Function

How Parameters Work
■ Octave Shift (Range: –2 to 0 to +2)

You can use octave shift to shift the range of the tone up or

The following are the parameters whose settings can be

down. When using the piccolo tone, there may be cases when

changed in the Parameter Edit Mode.

very high notes you want to play are not included within the

 

 

 

 

 

 

 

 

range of the keyboard. When this happens, you can use octave

Tone Parameters

shift to shift the keyboard range one octave up.

 

 

 

 

 

■ Tone

 

 

O c t S h i f t

 

(Range: 000 to 803, Drawbar organ tones 000 to 199)

 

 

 

This parameter controls the tones assigned to each part.

 

 

 

 

 

 

 

Anytime the tone is on the display, you can use the TONE

–2 : Range shifted two octaves down.

button or DRAWBAR ORGAN button and then select a

–1 : Range shifted one octave down.

different tone, if you want.

0 : No shift

 

 

 

 

+1 : Range shifted one octave up.

 

 

G r a n d P n o

 

+2 : Range shifted two octaves up.

 

 

 

 

 

 

 

■ Part On/Off (Settings: on, oFF)
Tuning Parameters

You can use these parameters to tune each of the parts

This parameter can be used to turn each part on (sounds)

individually.

and off (does not sound). The current on/off status of each

 

 

 

 

part is indicated on the display as described below.

■ Coarse Tune (Range: –24 to 00 to +24)

 

 

 

 

 

 

 

 

This parameter controls the coarse tuning of the selected

 

 

C h a n n e l

 

 

 

 

channel’s pitch in semitone units.

 

 

 

 

 

 

 

■ Volume (Range: 000 to 127)

 

 

C . T u n e

 

This is the parameter that controls the volume of the selected

 

 

 

 

 

 

 

channel.

■ Fine Tune (Range: –99 to 00 to +99)

 

 

 

 

 

 

 

 

This parameter controls the fine tuning of the selected

 

 

V o l ume

 

 

 

 

channel’s pitch in cent units.

 

 

 

 

 

 

 

■ Pan Pot (Range: –64 to 00 to +63)

 

 

F i n e T u n e

 

This parameter controls the pan pot, which is the center point

 

 

 

 

 

 

 

of the left and right stereo channels. Setting “00” specifies

 

 

 

 

center, a value less than “00” moves the point left, and a value

 

 

 

 

greater than “00” moves it right.

 

 

 

 

 

 

 

 

 

 

 

 

 

 

P a n

 

 

 

 

 

 

 

 

 

 

 

 

 

735A-E-051A

 

E-49

WK3100_e_47-58.p65

49

04.3.26, 0:11 PM