VFS113 Rack/Desktop Model User’s Guide
2Select 6. Utility Menu and press Enter. The Utility Menu screen displays.
3Select 2. Clear Configuration and press Enter.4The system confirms that you want to make the change. Enter Y to confirm and press Enter to clear the configurations.
5The system confirms that the changes are made.
6Press q to quit the Utility Menu.
7Select 5. Run Bridge to verify the configurations have been cleared.
Terminal Emulator and COM Port Problems
Problem: Screen continuously puts out garbage characters.
Solution: The likely cause of this problem is a baud rate mismatch between the terminal emulator and the router. The default baud rate is 115,200 bps. Follow these steps if you set your terminal emulator to this rate and still get garbage characters:
1Turn off the power to the router.
2Press the spacebar of your terminal emulator.
3Turn on the power while continuing to press the spacebar. This will allow the router to autodetect the baud rate setting.
4When the Flash Utility appears, select 5. Run Bridge to continue to boot the router.
Note: Some terminal emulators don’t immediately change to the new baud rate settings, and you have to exit and restart the emulator to use the new settings.