Cisco Systems 1130AG Cable Bay Area, Top of Unit, Message type, Ethernet LED, Radio LED, Meaning

Chapter 3 Troubleshooting Autonomous Access Points

Checking the Autonomous Access Point LEDs

The LED signals are listed in Table 3-1.

Table 3-1	LED Signals
		Cable Bay Area		Top of Unit
Message type		Ethernet LED	Radio LED	Status LED	Meaning
Operating status		Green	—	—	Ethernet link is operational.
		Blinking green	—	—	Transmitting or receiving Ethernet packets.
		—	Blinking green	—	Transmitting or receiving radio packets.
		—	—	Blinking	Software upgrade in progress
				dark blue
Association status		—	—	Light green	Normal operating condition, but no wireless
					client devices are associated with the unit.
		—	—	Blue	Normal operating condition, at least one wireless
					client device is associated with the unit.
Cisco IOS errors		Blinking amber	—	—	Transmit or receive Ethernet errors.
		—	Blinking amber	—	Maximum retries or buffer full occurred on the
					radio.
		Red	Red	Amber	Software failure; try disconnecting and
					reconnecting unit power.
		—	—	Amber	General warning, insufficient inline power (see
					the “Low Power Condition for Autonomous
					Access Points” section).
Boot loader status		Green	Green	Green	DRAM memory test ok.
		Off	Blinking green	Blue-green	Initialize Flash file system.
		Off	Green	Pink	Flash memory test ok.
		Green	Off	Dark blue	Ethernet test ok.
		Green	Green	Green	Starting Cisco IOS.
Boot loader warnings		Off	Off	Yellow	Ethernet link not operational.
		Red	Off	Yellow	Ethernet failure.
		Amber	Off	Yellow	Configuration recovery in progress
					(Mode button pressed for 2 to 3 seconds).
		Off	Red	Pink	Image recovery
					(Mode button pressed for 20 to 30 seconds).
		Blinking green	Blinking red	Blinking	Image recovery in progress and Mode button is
				pink	released.

Cisco Aironet 1130AG Series Access Point Hardware Installation Guide

OL-8369-05 3-3