Component Description | Cisco Systems 545 Serial specification

Chapter 2 Installing the Cisco Unified Videoconferencing 3545 Gateway

Physical Description

Figure 2-1 Gateway Front Panel

Table 2-1	Front Panel Components

Component		Description

10/100 Base T-1		An RJ-45 connector that provides the primary Ethernet connection for the IP
connector		network port.

SERIAL connector		A DB-9 connector that allows you to connect a PC terminal for local
		configuration.

RST button		Allows you to reset the gateway manually.

GK Reg LED		Lights green when the gateway is registered with a gatekeeper.

CD LED		Lights green when at least one gateway port connection is online.

ACT LED		Lights green to indicate that there are active calls in the gateway.

ALARM LED		Lights green to indicate that an error has occurred and the gateway requires
		resetting.

10/100 Base T-1 LEDs		The top part of the 10/100 Base T-1 connector contains two LED indicators.
		The left-hand LED lights green when the local IP network link is active. The
		right-hand LED lights green if the connection speed is 100 Mbps, and is off
		when the connection speed is 10 Mbps.

SWAP RDY LED		Hot Swap indication. Lights blue when the latches of a board are unlocked
		and it is safe to remove the board from the chassis. Goes off when the board
		is completely detached.

The Rear Transition Module (RTM) provides the PRI line connections for the Cisco Unified

Videoconferencing 3545 PRI Gateway.

Table 2-2 PRI Gateway Rear Transition Module Components

157272

		Component	Description

		ACT LEDs	Lights green to indicate that there are active calls in the gateway.

		D-Ch LEDs	Lights green to indicate that the PRI line is enabled and a carrier signal is
			detected.

	Installation and Upgrade Guide for Cisco Unified Videoconferencing 3545 PRI Gateway and 3545 Serial Gateway Release 5.5


2-2			OL-14912-01
2-2			OL-14912-01