Chapter 2 Installing the Cisco Unified Videoconferencing 3545 Gateway

Initial Gateway Configuration

The network configuration Main menu displays:

Press any Key To start configuration...

Main menu

Enter <N> to configure default network port values

Enter <P> to change the configuration software password

Enter <A> to display advanced configuration menu

Enter <Q> to quit configuration menu and start GW

Caution If you do not press a key before the countdown ends, the device continues its initialization and you can only configure the device by pressing the RST button on the front panel.

Step 8 At the prompt, type N to configure default network port values and press Enter.

Step 9 At the Enter IP address for default interface prompt, type the IP address you want to assign to the gateway and press Enter.

Caution Do not use leading zeros in the IP address.

Step 10 At the Enter Default Router IP Address prompt, type the IP address of the router associated with the segment in which the unit will be installed and press Enter.

Caution Do not use leading zeros in the IP address.

Step 11 At the Enter IP Mask for default device prompt, type the subnet mask without leading zeros, and then press Enter. If a subnet mask is not used, press Enter.

Step 12 Allow the unit to complete the reboot process. A new emulator session begins.

Step 13 Close the terminal emulator session.

Changing the Configuration Tool Login Password

You can use the terminal emulator to change the default password of the default login user before others can use the gateway interface.

Procedure

Step 1 Start a terminal emulator session for the gateway.

Step 2 Press the RST button on the front panel of the gateway.

After 60 seconds, a new terminal emulator session begins on the computer monitor.

Step 3 After the second VxWorks banner scrolls across the screen, the following message appears: “Press any Key to start the configuration.”

Step 4 Press any key and then press Enter.

Step 5 At the prompt, enter P and press Enter to select “change the configuration software password.” Step 6 Type the user login name for which you want to change the password and press Enter.

The default user name is admin. This is the user name that allows you to access the gateway interface.

 

Installation and Upgrade Guide for Cisco Unified Videoconferencing 3545 PRI Gateway and 3545 Serial Gateway Release 5.5

2-12

OL-14912-01

Page 32
Image 32
Cisco Systems 545 Serial manual Changing the Configuration Tool Login Password, Network configuration Main menu displays