C H A P T E R 2

Installing the Cisco Unified

Videoconferencing 3545 Gateway

This section describes the following topics:

Physical Description, page 2-1

Preparing for Installation, page 2-3

Verifying the Package Contents, page 2-4

Mounting the Cisco Unified Videoconferencing 3545 Chassis in a 19-inch Rack, page 2-5

Installing the Gateway, page 2-6

Initial Gateway Configuration, page 2-10

Connecting the Gateway to the Network, page 2-14

Connecting PRI Lines to the Gateway, page 2-14

Connecting Serial Lines to the Gateway, page 2-14

Serial Gateway Cable Connections and Pin-outs, page 2-15

Connecting the Gateway to a Power Source, page 2-27

Accessing the Gateway Administrator Interface, page 2-27

Registering the Online Help, page 2-28

Physical Description

This section provides a physical description of the gateway modules and their corresponding RTMs.

Gateway Module

The gateway module has a 10/100BaseT Ethernet port on the front panel that uses an RJ-45 connector to connect to the network. There is an asynchronous, 9-pin serial port that you can use with a hyperterminal program to configure and monitor the module.

Figure 2-1shows the front panel components of the gateway module. Table 2-1describes these components.

Installation and Upgrade Guide for Cisco Unified Videoconferencing 3545 PRI Gateway and 3545 Serial Gateway Release 5.5

 

OL-14912-01

2-1

 

 

 

Page 21
Image 21
Cisco Systems 545 Serial Installing the Cisco Unified Videoconferencing 3545 Gateway, Physical Description, Gateway Module