Chapter 2 Installing the Cisco Unified Videoconferencing 3545 Gateway

Installing the Gateway

Installing the Gateway

This section describes how to insert a gateway into the Cisco Unified Videoconferencing 3545 chassis.

Before You Begin

Note the following:

The Cisco Unified Videoconferencing 3545 chassis has four slots. You can install the Cisco Unified Videoconferencing 3545 Gateway in any of the slots.

Insert the gateway in the top slot at the front of the Cisco Unified Videoconferencing 3545 chassis to view status and identification information via the System web user interface.

The Cisco Unified Videoconferencing 3545 Gateway has two components that you must install in the chassis: the Cisco Unified Videoconferencing 3545 Gateway module and the corresponding Rear Transition Module (RTM), as indicated in Table 2-5.

 

 

Table 2-5

Identifying RTM Boards

 

 

 

 

 

 

 

 

 

 

Gateway

 

Corresponding RTM

 

 

Cisco Unified Videoconferencing 3545

Dual PRI RTM board

 

 

PRI Gateway

 

 

 

 

 

 

 

 

 

 

Cisco Unified Videoconferencing 3545

Quad Serial RTM board

 

 

Serial Gateway

 

 

 

 

 

 

 

 

 

 

The gateway module installs in the front of the chassis and provides ISDN or serial functionality. The

 

 

RTM installs in the rear of the chassis and provides the physical interface for the ISDN or serial line.

 

 

You must install these modules in corresponding slots in the chassis. That is, if you insert the gateway

 

 

module in the top slot in the front of the chassis, you must insert the RTM in the top slot in the rear of

 

 

the chassis.

 

 

 

 

 

 

 

 

Warning

During this procedure, wear grounding wrist straps to avoid ESD damage to the card. Do not directly touch the

 

 

backplane with your hand or any metal tool, or you could shock yourself.

Only trained and qualified personnel should be allowed to install, replace, or service this equipment.

Before working on a system that has an on/off switch, turn OFF the power and unplug the power cord.

Before opening the chassis, disconnect the telephone network cables to avoid contact with telephone network voltages.

To avoid electric shock, do not connect safety extra-low voltage (SELV) circuits to telephone-network voltage (TNV) circuits. LAN ports contain SELV circuits, and WAN ports contain TNV circuits. Some LAN and WAN ports both use RJ-45 connectors. Use caution when connecting cables.

The telecommunications lines must be disconnected 1) before unplugging the main power connector and/or 2) while the housing is open.

Installation and Upgrade Guide for Cisco Unified Videoconferencing 3545 PRI Gateway and 3545 Serial Gateway Release 5.5

2-6

OL-14912-01

 

 

Page 26
Image 26
Cisco Systems 545 Serial manual Installing the Gateway, Before You Begin