Appendix F Cisco Unified IP Phone Non-Lockable Wall Mount

ADA Non-Lockable Wall Mount Kit for 8961 Series and 9900 Series IP Phones

The package contains the following items:

One phone bracket

One wall bracket

Four #8-18 x 1.25-inch Phillips-head screws with four anchors

Two #4-40 x 0.31-inch machine screws

One 6-inch Ethernet cable

Before you begin

You need these tools to install the bracket:

#1 and #2 Phillips-head screwdrivers

Level

Pencil

You must also install an Ethernet jack for the telephone in the desired location if an Ethernet jack does not currently exist. This jack must be wired appropriately for an Ethernet connection. You cannot use a regular telephone jack. For more information about phone installation requirements and warnings, see Setting Up the Cisco Unified IP Phone, page 3-1.

Install Non-Lockable Wall Mount for phone

The wall mount kit can be mounted on most surfaces, including concrete, brick, and similar hard surfaces. To mount the kit on concrete, brick, or similar hard surfaces, you must provide the appropriate screws and anchors for your wall surface.

Procedure

Step 1 Mount the wall bracket in the desired location. You can install the bracket over an Ethernet jack, or you can run the Ethernet network cable to a jack nearby.

Note If the jack is to be placed behind the phone, the Ether net jack must be flush to the wall or recessed.

a.Hold the bracket on the wall, placing it so that the arrow on the back of the bracket is pointing up.

b.Use the level to ensure the bracket is level, then use a pencil to mark the screw holes.

c.Using a #2 Phillips-head screwdriver, carefully center the anchor over the pencil mark and press the anchor into the wall.

d.Screw the anchor clockwise into the wall until it is seated flush.

e.Use the included screws and a #2 Phillips-head screwdriver to attach the bracket to the wall.

The following figure shows the bracket installation steps.

Cisco Unified IP Phone 8961, 9951, and 9971 Administration Guide for Cisco Unified Communications Manager 8.5 (SIP)

 

F-4

OL-20861-01

 

 

 

Page 252
Image 252
Cisco Systems 8961 manual Before you begin, Install Non-Lockable Wall Mount for phone