Cisco Systems 8961 manual Installing the Bracket

Appendix E Installing the Wall Mount for the Cisco Unified IP Phone

Installing a Wall Mount for a Phone with a Key Expansion Module

Installing the Bracket

To install the phone on the wall, perform the following steps:

Note Be sure to connect to connect the Cisco Unified IP Phone to the Key Expansion Module prior to installing the phone bracket.

Procedure

Step 1 Mount the wall bracket in the desired location (Figure E-8). You can install the bracket over an Ethernet jack, or you can run the Ethernet network cable to a jack nearby.

a.Use the level to ensure the bracket is level, then use a pencil to mark the screw holes.

b.Using a #2 Phillips-head screwdriver, carefully center the anchor over the pencil mark and press the anchor into the wall.

c.Screw the anchor clockwise into the wall until it is seated flush.

d.Use the included screws and a #2 Phillips-head screwdriver to attach the bracket to the wall.

Cisco Unified IP Phone 8961, 9951, and 9971 Administration Guide for Cisco Unified Communications Manager 8.5 (SIP)

OL-20861-01 E-9