Chapter 5 Setting Up the Cisco Unified Video Camera

Post-Installation Steps

Step 3 Highlight Cisco Unified Camera.

Step 4 Press the Set-upsoftkey.

Step 5 Press the Turn On or Turn Off softkey.

Post-Installation Steps

After installing the Cisco Unified Video Camera, perform the following checks:

1.Wait till the “camera ready” message appears.

Note The camera may need to upgrade after installation. This may take a few minutes before the camera is operational.

2.Press the Video Preview softkey to check the picture quality.

If the video preview image looks too blue, try increasing the camera Brightness setting.

If the background looks washed out, try decreasing the camera Brightness setting.

Note For information about adjusting camera settings on the phone, see the Cisco Unified Video Camera Quick Start Guide at this location: http://www.cisco.com/en/US/products/ps10655/products_user_guide_list.html

3.Move the phone/camera to a position where there are no bright lights in the field of view.

4.Move the phone/camera so that the user is illuminated by light coming from the front.

Using the Cisco Unified Video Camera

For information about placing and receiving video calls, setting up video conferences, and adjusting camera settings on the phone, see the Cisco Unified Video Camera Quick Start Guide at this location:

http://www.cisco.com/en/US/products/ps10655/products_user_guide_list.html

Cisco Unified IP Phone 8961, 9951, and 9971 Administration Guide for Cisco Unified Communications Manager 8.5 (SIP)

5-4

OL-20861-01

 

 

Page 90
Image 90
Cisco Systems 8961 manual Post-Installation Steps, Using the Cisco Unified Video Camera