
Appendix F Cisco Unified IP Phone
ADA
The package contains the following items:
•One phone bracket
•One wall bracket
•Six
•Three
•One
Before You Begin
You need these tools to install the bracket:
•#1 and #2
•Level
•Pencil
You must also install an Ethernet jack for the telephone in the desired location if an Ethernet jack does not currently exist. This jack must be wired appropriately for an Ethernet connection. You cannot use a regular telephone jack. For more information about phone installation requirements and warnings, see Setting Up the Cisco Unified IP Phone, page
Install
The wall mount kit can be mounted on most surfaces, including concrete, brick, and similar hard surfaces. To mount the kit on concrete, brick, or similar hard surfaces, you must provide the appropriate screws and anchors for your wall surface.
Note Be sure to connect to connect the Cisco Unified IP Phone to the Key Expansion Module before installing the phone bracket.
Step 1 Mount the wall bracket in the desired location. You can install the bracket over an Ethernet jack, or you can run the Ethernet network cable to a nearby jack.
Note If the jack is to be placed behind the phone, the Ethernet jack must be flush to the wall or recessed.
a.Hold the bracket on the wall. See the following figure for the orientation of the wall bracket.
b.Use the level to ensure that the bracket is level and use a pencil to mark the screw holes.
c.Using a #2
d.Screw the anchor clockwise into the wall until it is seated flush.
e.Use the included screws and a #2
The following figure shows the steps for installing the bracket.
Cisco Unified IP Phone 8961, 9951, and 9971 Administration Guide for Cisco Unified Communications Manager 8.5 (SIP)
|
| |
|