Send document comments to nexus7k-docfeedback@cisco.com
6-33
Cisco Nexus 7000 Series Hardware Installation and Reference Guide
OL-18634-01
Chapter 6 Managing the Device Hardware
EPLD Configuration
Mod Ports Module-Type Model Status
--- ----- -------------------------------- ------------------ ------------
1 48 10/100/1000 Mbps Ethernet Module N7K-N148GT-11 ok
3 32 10 Gbps Ethernet Module N7K-M132XP-12 ok
5 0 Supervisor module-1X N7K-SUP1 active
6 0 Supervisor module-1X N7K-SUP1 ha-standby
10 48 10/100/1000 Mbps Ethernet Module N7K-M148GT-11 ok
Mod Sw Hw World-Wide_name(s) (WWN)
--- -------------- ------ -------------------------------------------------
1 4.0(2) 0.503 --
3 4.0(2) 0.601 --
5 4.0(2) 0.900 --
6 4.0(2) 0.802 --
10 4.0(2) 0.902 --
Mod MAC-Address(es) Serial-Num
--- -------------------------------------- ----------
1 00-19-07-6c-c0-6c to 00-19-07-6c-c0-a0 JAB11060144
3 00-1b-54-c1-33-98 to 00-1b-54-c1-33-bc JAB1152010K
5 00-1b-54-c1-16-18 to 00-1b-54-c1-16-20 JAB114902HF
6 00-19-07-c1-00-b8 to 00-1b-54-c1-00-c0 JAB114402JX
10 00-1b-54-c1-07-88 to 00-1b-54-c1-07-bc JAB114501RW
* this terminal session
switch#

Step 2 Install the EPLDs by entering the install module slot_number epld url command.

switch# install module 6 epld bootflash:n7000-s1-epld.4.0.2.img
EPLD image file , built on Fri May 16 20:36:39 2008
EPLD Curr Ver New Ver
-------------------------------------------------------
Power Manager 3.4 3.6
IO 3.23 3.23
Inband 1.7 1.7
Local Bus CPLD 2.1 2.1
CMP CPLD 6.0 6.0
WARNING: Upgrade process could take upto 30 minutes.
Standby supervisor is being upgraded.
Do you want to continue (y/n) ?

Step 3 Begin upgrading the EPLD images by entering Y for yes.

Do you want to continue (y/n) ? Y

Step 4 For releases 4.0(2) or earlier, if you updated the power management E PLD image, you must reset the

power for the module so that EPLD can take effect (this is not required for release 4.0(3) o r later). You can reset the power in one of the following two ways:

• To reset the power for the module, physically remove the module and reinstall it.

Note A module reload or just pressing the ejector buttons on the module is not sufficient for this

reset requirement.

• To reset the entire system, power cycle the system.