Chapter 8 Removal and Installation Procedures
Replacing a CompactFlash Card
Se n d d o c u m e n t c o m m e n t s t o n ex u s 7 k - d o c f e e d b a ck @ c i s c o . c o m
If the card does not fit easily into the slot, flip the card so the bottom edge is on top, and try pushing the card into the slot.
Step 7 Wait for the reader LED to turn green and for a message to appear on the console.
•If you are installing a card into the log flash reader, the message will end with “logflash:online.”
switch# 2008 Mar 15 08:00:00 switch %$
•If you are installing a card into the expansion flash reader, the message will end with “slot0:online.”
switch# 2008 Mar 15 08:00:00 switch %$
•If you see an offline message or do not see a message, either the card is not fully pushed into the reader or it is improperly formatted.
switch# 2008 Dec 1 12:00:00 switch %$
Make sure that the card is fully inserted inside the reader. If the card is fully inserted, either format the card (see the Cisco
Step 8 Remove the bottom frame assembly by completely unscrewing the four screws identified in Figure
Figure 8-5 Removing the Bottom Frame
186696
Step 9 Remove the front doors on the middle of the frame by unscrewing the six screws (three on each side) identified in Figure
| Cisco Nexus 7000 Series Hardware Installation and Reference Guide |
|