Cisco Systems 7100 Series quick start Start the System

Start the System (continued)

7 Configure the Fast Ethernet LAN port in slot 0. Use your own addresses and subnet mask at the setup prompts. Consult with your network administrator for this information.

Configuring interface parameters:

Do you want to configure FastEthernet0/0 interface? [yes]: yes

Use the 100 Base-TX (RJ-45) connector? [yes]: yes

Operate in full-duplex mode? [no]: yes

Configure IP on this interface? [yes]: yes

IP address for this interface: 10.0.0.0

Subnet mask for this interface [255.0.0.0]:

Class A network is 10.0.0.0, 8 subnet bits; mask is /8

Do you want to configure FastEthernet0/1 interface? [yes]: no

Note: Many of the interface LEDs do not go on until you have configured them. To verify correct operation of each interface, complete the first-time startup procedures and configuration, and then refer to the LED descriptions in Chaper 1, “Cisco 7100 Series VPN Router Product Overview” in the Cisco 7100 Series VPN Router Installation and Configuration Guide to check the status of the interfaces.

8	Configure the ATM port in slot 1. Use your own addresses and subnet mask at the setup
	prompts. Consult with your network administrator for this information.
	Do you want	to configure ATM1/0 interface? [yes]: yes
	Configure	IP on this interface? [yes]: yes
	IP address for this interface: 10.0.0.10
	Subnet mask for this interface [255.0.0.0]:
	Class A	network is 10.0.0.10, 8 subnet bits; mask is /8
	Do you want	to configure ATM2/0 interface? [yes]:no
9	Configure the synchronous serial port in slot 4. Use your own addresses and subnet mask
	at the setup prompts. Consult with your network administrator for this information.
	Do you want	to configure Serial4/0 interface 3/0 [yes]: yes
	Configure IP on this interface? [yes]: yes
	IP address for this interface: 10.1.1.20
	Number of bits in subnet field [0]:
	Class A	network is 10.1.1.0, 0 subnet bits; mask is /24

19