ACIP Installation Prerequisites
Figure 7 shows the rear of the 7-slot Cisco 7507 router. In the Cisco 7507, up to two slots (2 and 3) are reserved for the Route Switch Processor (RSP2), which contains the system processor and performs packet switching functions. Slots 0 and 1, and 4 through 6 are for interface processors, including the ACIP. (There are no restrictions on slot locations or sequence; you can install an ACIP in any available interface processor slot.)
Figure 7 Cisco 7507, Interface Processor End
Captive installation screw 
| DC |
| FAIL |
| AC |
| POWER |
Upper | |
power supply | |
Chassis | |
grounding | I |
receptacles | |
| O |
Captive | |
installation screw | |
| DC |
| FAIL |
| AC |
| POWER |
Lower | |
power supply | |
| I |
| O |
| | NORMAL | | | ENABLE | |
| | | | | |
| | | EJECT | | | |
| | SLOT | SLOT | 1 | | | |
| | 0 | | | |
| | SLAVEMASTER | | | |
| | SLAVE/MASTER | | | |
| | | CPU | HALT | | | |
| | | | | ENABLE | |
| | | RESET | | |
| | | | | | | H3888 |
| | AUX. | | | | |
| | CONSOLE | ROUTE | | | |
| | SWITCHPROCESSOR2 | | | |
| | | | | | |
Slot 0 | 1 | 2 | | 3 | 4 | 5 | 6 |
10ATM Cable Interface Processor (ACIP) Installation and Configuration
