Cisco Systems AIR-CT2504-5-K9, 2500 manual Mounting Screw Holes on the Back of the Controller

Warning	Read the wall-mounting carefully before beginning installation. Failure to use the
	correct hardware or to follow the correct procedures could result in a hazardous
	situation to people and damage to the system. Statement 378

To mount the controller on a wall using mounting screws, follow these steps:

Step 1 Mark the location of the mounting screws on the wall. Use the mount hole locations on the back of the controller for placement of the mounting screws (Figure 7). (The mount holes are shown in Figure 7 with a cross-hatch mark.)

Figure 7 Mounting Screw Holes on the Back of the Controller

5.5

3.9

FRONT PANEL

282087

Step 2 Use a 0.107-inch (2.7mm) or #32 drill bit to drill a 3/4 inch (19mm) hole for the two mounting screws.

Step 3 Insert two screws into the screw holes and tighten until the top of the screws are 1/8 inch from the wall (leaving enough room for the back panel to slide onto the screws firmly).

16