Step 3 Observe the bootup using the CLI screen.
The bootup script displays operating system software initialization (code download and POST verification) and basic configuration as shown in the following bootup display example:
CISCO SYSTEMS
WLCNG Boot Loader Version 1.0.15 (Built on Nov 23 2010 at 07:51:36 by cisco) Board Revision 0.0 (SN: PSJ143302MT, Type:
Verifying boot loader integrity... OK.
OCTEON
CPU Cores: 4
DRAM: 1024 MB
Flash: 32 MB
Clearing DRAM........ done
Network: octeth0', octeth1, octeth2, octeth3 ' - Active interface
E - Environment MAC address override
CF Bus 0 (IDE): OK
IDE device 0:
-Model: 1GB CompactFlash Card Firm: CF B612J Ser#: C181101244A1Yb3A5QNU
-Type: Hard Disk
-Capacity: 977.4 MB = 0.9 GB (2001888 x 512)
Press <ESC> now to access the Boot Menu...
Continue booting the controller or press Esc to access the following menu:
============================================================
Boot Loader Menu
============================================================
1.Run primary image (7.0.114.76) - Active
2.Run backup image (7.0.114.75)
3.Change active boot image
4.Clear configuration
5.Format FLASH Drive
6.Manually update images
Enter selection:
If you did not press Esc, the boot process continues and takes two to three minutes. Do not reboot the controller until the user login prompt appears. Loading primary image (7.0.114.76)
100%
31427987 bytes read Launching images...
init started: BusyBox v1.6.0
starting pid 672, tty '': '/etc/init.d/rcS' type = block
level = header
24
