Cisco Systems ME 3400 Enabling and Configuring Port Security

22-12
Cisco ME 3400 Ethernet Access Switch Software Configuration Guide
OL-9639-06
Chapter 22 Configuring Port-Based Traffic Control
Configuring Port Security
Table 22-3 summarizes port security compatibility with other port-based features.
Enabling and Configuring Port Security
Beginning in privileged EXEC mode, follow these steps to restrict input to an interface by limiting and
identifying MAC addresses of the stations allowed to access the port:
Tab le 22-3 Port Security Compatibility with Other Switch Features
Type of Port or Feature on Port Compatible with
Port Security
Trunk port Yes
Dynamic-access port (a VLAN Query Protocol [VQP] port configured with the
switchport access vlan dynamic interface configuration command) No
Routed port No
SPAN source port Yes
SPAN destination port No
EtherChannel No
Tunneling port Yes
Protected port Yes
802.1x port Yes
Private VLAN port No
IP source guard Yes
Dynamic Address Resolution Protocol (ARP) inspection Yes
Flex Links Yes
Command Purpose
Step 1 configure terminal Enter global configuration mode.
Step 2 interface interface-id Specify the interface to be configured, and enter interface configuration
mode.
Step 3 no shutdown Enable the port, if necessary. By default, UNIs and ENIs are disabled, and
NNIs are enabled.
Step 4 switchport mode {access | trunk}Set the interface switchport mode as access or trunk; an interface in the
default mode (dynamic auto) cannot be configured as a secure port.
Step 5 switchport port-security Enable port security on the interface.