34-19
Cisco ME 3400 Ethernet Access Switch Software Configuration Guide
OL-9639-06
Chapter 34 Configuring EtherChannels and Link-State Tracking Configuring EtherChannels
To return the priority to its default setting, use the no pagp port-priority interface configuration
command. To return the learning method to its default setting, use the no pagp learn-method interface
configuration command.
Configuring LACP Hot-Standby Ports
When enabled, LACP tries to configure the maximum number of LACP-compatible ports in a channel,
up to a maximum of 16 ports. Only eight LACP links can be active at one time. The software places any
additional links in a hot-standby mode. If one of the active links becomes inactive, a link that is in the
hot-standby mode becomes active in its place.
Note LACP is only available on NNIs and ENIs.
Step 3 pagp learn-method physical-port Select the PAgP learning method.
By default, aggregation-port learning is selected, which means
the switch sends packets to the source by using any of the ports
in the EtherChannel. With aggregate-port learning, it is not
important on which physical port the packet arrives.
Select physical-port to connect with another switch that is a
physical learner. Make sure to configure the port-channel
load-balance global configuration command to src-mac as
described in the “Configuring EtherChannel Load Balancing”
section on page 34-17.
The learning method must be configured the same at both ends
of the link.
Note If the interface is a UNI, you must enter the port-type
{eni | nni} interface configuration command before
configuring PAgP.
Step 4 pagp port-priority priority Assign a priority so that the selected port is chosen for packet
transmission.
For priority, the range is 0 to 255. The default is 128. The higher
the priority, the more likely that the port will be used for PAgP
transmission.
Step 5 end Return to privileged EXEC mode.
Step 6 show running-config
or
show pagp channel-group-number internal
Verify your entries.
Step 7 copy running-config startup-config (Optional) Save your entries in the configuration file.
Command Purpose