28-11
Cisco ME 3400 Ethernet Access Switch Software Configuration Guide
OL-9639-06
Chapter 28 Configuring System Message Logging Configuring System Message Logging
Use the show archive log config {all | number [end-number] | user username [session number] number
[end-number] | statistics} [provisioning] privileged EXEC command to display the complete
configuration log or the log for specified parameters.
The default is that configuration logging is disabled.
For information about the commands, see the Cisco IOS Configuration Fundamentals and Network
Management Command Reference, Release 12.3 T at this URL:
http://www.cisco.com/en/US/products/sw/iosswrel/ps5207/products_command_reference_chapter0918
6a00801a8086.html#wp1114989
Beginning in privileged EXEC mode, follow these steps to enable configuration logging:
This example shows how to enable the configuration-change logger and to set the number of entries in
the log to 500.
Switch(config)# archive
Switch(config-archive)# log config
Switch(config-archive-log-cfg)# logging enable
Switch(config-archive-log-cfg)# logging size 500
Switch(config-archive-log-cfg)# end
This is an example of output for the configuration log:
Switch# show archive log config all
idx sess user@line Logged command
38 11 unknown user@vty3 |no aaa authorization config-commands
39 12 unknown user@vty3 |no aaa authorization network default group radius
40 12 unknown user@vty3 |no aaa accounting dot1x default start-stop group
radius
41 13 unknown user@vty3 |no aaa accounting system default
42 14 temi@vty4 |interface GigabitEthernet4/0/1
43 14 temi@vty4 | switchport mode trunk
44 14 temi@vty4 | exit
45 16 temi@vty5 |interface FastEthernet5/0/1
46 16 temi@vty5 | switchport mode trunk
47 16 temi@vty5 | exit
Command Purpose
Step 1 configure terminal Enter global configuration mode.
Step 2 archive Enter archive configuration mode.
Step 3 log config Enter configuration-change logger configuration mode.
Step 4 logging enable Enable configuration change logging.
Step 5 logging size entries (Optional) Configure the number of entries retained in the configuration
log. The range is from 1 to 1000. The default is 100.
Note When the configuration log is full, the oldest log entry is removed
each time a new entry is entered.
Step 6 end Return to privileged EXEC mode.
Step 7 show archive log config Verify your entries by viewing the configuration log.