Cisco Systems ME 3400 Enabling and Disabling Sequence Numbers in Log Messages, Defining the Message Severity Level

28-8
Cisco ME 3400 Ethernet Access Switch Software Configuration Guide
OL-9639-06
Chapter 28 Configuring System Message Logging
Configuring System Message Logging
This example shows part of a logging display with the service timestamps log uptime global
configuration command enabled:
00:00:46: %LINK-3-UPDOWN: Interface Port-channel1, changed state to up
Enabling and Disabling Sequence Numbers in Log Messages
Because there is a chance that more than one log message can have the same time stamp, you can display
messages with sequence numbers so that you can unambiguously see a single message. By default,
sequence numbers in log messages are not displayed.
Beginning in privileged EXEC mode, follow these steps to enable sequence numbers in log messages.
This procedure is optional.
To disable sequence numbers, use the no service sequence-numbers global configuration command.
This example shows part of a logging display with sequence numbers enabled:
000019: %SYS-5-CONFIG_I: Configured from console by vty2 (10.34.195.36)
Defining the Message Severity Level
You can limit messages displayed to the selected device by specifying the severi ty level of the message,
which are described in Tabl e 28-3.
Beginning in privileged EXEC mode, follow these steps to define the message severity level. This
procedure is optional.
Command Purpose
Step 1 configure terminal Enter global configuration mode.
Step 2 service sequence-numbers Enable sequence numbers.
Step 3 end Return to privileged EXEC mode.
Step 4 show running-config Verify your entries.
Step 5 copy running-config startup-config (Optional) Save your entries in the configuration file.
Command Purpose
Step 1 configure terminal Enter global configuration mode.
Step 2 logging console level Limit messages logged to the console.
By default, the console receives debugging messages and numerically
lower levels (see Table 28-3 on page 28-9).
Step 3 logging monitor level Limit messages logged to the terminal lines.
By default, the terminal receives debugging messages and numerically
lower levels (see Table 28-3 on page 28-9).